Power UNITS FOR LIFT TABLE one
General Description
This energy unit is made exclusively for your modest lift table,Consisting of high stress gear pump, AC motor, multi-functional manifold, valves, tank, etc. This energy unit has become extensively made use of in the field of logistic gadgets such as minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is controlled from the solenoid valve using the pace managed by the adjustable needle valve.
Energy UNITS FOR LIFT TABLE 2
Basic Description
This power unit is built solely to the medium lift table, Consisting of extremely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve along with the speed controlled by the adjustable needle valve. When the lift rises to a high positoin, however the power supply is lower, the lowering movement is controlled by the manual override function.
Energy UNITS FOR LIFT TABLE 3
Basic Description
This energy unit is developed exclusively for your big lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve and also the velocity managed by a stress compensated movement management valve.
Energy UNITS FOR LIFT TABLE four
Common Description
This electrical power unit is developed exclusively for the large lift table, Consisting of highly effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived through the solenoid valve as well as the velocity managed through the adjustable needle valve. Once the lift rises to a higher positoin, but the power provide is lower, the decreasing movement is managed from the guide override function.
Specific Notes
one. This power unit is of S3 duty cycle, which could only operate intermittently and repeatedly, i.e. 1 minute on and 9 minutes off.
2. Clean each of the hydraulic elements concerned prior to installation of the power unit.
three. Viscosity in the oil shoud be 15~46 cst,which should also be clean and free of charge of impurities.N46 hydraulic oil is advised.
4. Oil altering is needed right after the original one hundred operation hrs,afterwards as soon as every single 3000 hrs.
5. The energy unit proven is created to be mounted vertically.